Link 16 Practice Test

These questions are part of the practice quiz. Start practicing

• Who coordinates network management procedures and updates slot assignments in Link 16 operations?
• What kind of fighter-to-fighter (F2F) capability does the MH-60R have?
• What J-series message is for a surface track?
• If the network time is changed to an earlier time while in fine sync, what happens to non-NTRs and the NTR?
• What does BLOS stand for in Link 16 terminology?
• Which J-series message is for an emergency point?
• Who is assigned time slots in a Network Participation Group that relate to their mission?
• Full Link Mode/Suppression Disabled means:
• Which of the following is a major hardware element of the Link-16 sub system (in our helicopter)?
• Can the ROMEO see J14.0 messages?
• What is the backbone hardware element that enables MH-60R access to Link 16?
• What does the acronym NDL stand for in Link 16 terms?
• Which component provides the ability to load crypto keys?
• How does a unit join a Link 16 network and begin transmitting?
• How does Link 16 help with over the horizon targeting?
• How does the network decide which data gets priority on the TDMA frame?
• How is data integrity maintained in Link 16 transmissions?
• How many blade antennas are used and what is their arrangement?
• Which category includes vert rep, medevac, and passenger transfer as examples?
• How many engagements can be accepted by the system?
• Which component provides the zeroize signal?
• What should operators do if they detect a key mismatch or security anomaly?
• What J-series message is for a land point/track?
• What does the Interference Blanker provide?
• Which statement best describes how near-real-time data sharing is achieved in Link 16?
• How are LPAs (Lines, Points, and Areas) provided by Link 16?
• What is a J-Series message?
• Which components provide cryptographic support in a Link 16 network?
• What messages are used to input navigational information to the network?
• In Link 16, what is the purpose of time synchronization (NTR)?
• Which statement accurately describes buoy limitations in Link 16?
• Which approach enables interoperability across different services in Link 16?
• What is Time Slot Duty Factor (TSDF) and how does it limit Link 16 capabilities?
• What are the three requirements to access Link 16?
• How does the TDMA principle work?
• What is the role of the Net Control Station in a Link 16 network?
• Which of the following is NOT listed as a mission supported by Link 16 for the Romeo?
• How can a MIDS terminal support joint operations with other services?
• Why is suppression possible to be enabled but inactive?
• How often does a track update in this system?
• In Link 16, what data types are exchanged, beyond track data?
• What is the purpose of the Network Time Reference (NTR) in Link 16?
• What does PPLI stand for?
• In the data update workflow, which element converts sensor data into a Link 16 data message?
• Which are typical categories of Link 16 data messages?
• How does the TDMA frame structure enable multi-user access without collisions?
• Which J-series message is for a reference point, area, or one/two segments lines?
• What prevents two units from transmitting simultaneously on the same link in a Link 16 net?
• How many frequencies are available for JTIDS transmissions?
• What MIDS control limitations exist INCONUS?
• Which platform is specifically noted as restricted from generating and delegating assignments with FTF?
• What does STANAG 5514 govern in relation to Link 16?
• In Normal Mode/Suppression Enabled, ESM suppression is activated when which condition occurs?
• What algorithm is used for compression of images sent on Link 16?
• What is the significance of track updates being real-time in Link 16?
• How are track data typically represented on operator displays?
• If a line segment exceeds 100 NM, what happens before transmission to AMP?
• What happens when you send a Link 16 message to AMP?
• What J-series message is for a space track?
• What is the correct sequence for a data update from a sensor to other participants in a Link 16 network?
• Which option is not a valid IPF level?
• Which is a typical symptom of interference on a Link 16 network?
• What should you verify with your JICO or with the NDF regarding IPF settings?
• What is Link 16 used for?
• What is the function of encryption keys and crypto devices in Link 16?
• What is the track quality of a J3.4 message?
• Which platform can transmit surveillance tracks to the Link-16 network while conducting coordinated weapons engagements?
• How does data latency affect decision-making in Link 16-enabled missions?
• How are nets stacked in Link 16?
• What J-series message is for electronic warfare product info?
• What is the purpose of redundancy in Link 16 networks?
• What are the main benefits and limitations of Link 16 for modern joint operations?
• What is PPLI used for?
• How are slot allocations communicated to participating units?
• What happens if the NTR decides to change the network time?
• What does IPF OVRD do?
• How does Link 16 support resilience against node failure?
• How does Link 16 interface with higher-level C2 or ISR systems?
• Which type of Link 16 message carries information used for joining the net, keys, time, and status?
• What is the final verification step in the typical MIDS-LVT terminal net participation sequence?
• Which statement best describes a typical use of Link 16 data?
• Which type of Link 16 message carries track and position updates?
• What does NORM mode indicate in Link 16 settings?
• Which standard governs interoperability and data-sharing practices for Link 16 with partner nations?
• In Dip Boss/SAC operation through Link 16, which approach is recommended instead of J-messages?
• Which combination best maintains EMCON readiness while enabling critical data sharing?
• What happens when aborting an engaged Link 16 track that has a weapon?
• Which component handles joining/leaving the net and the exchange of time sync and encryption keys in Link 16?
• In the JTIDS architecture, which platform is capable of transmitting surveillance tracks to the network while conducting coordinated weapons engagements?
• How do you pass reporting responsibility of a J3.4 track?
• How often will a contact update?
• Which IPF settings are referenced in the material?
• What is the purpose of blue force tracking in Link 16?
• How is a SAR REF point special?
• What does the CONTROL INTEROP window display?
• What is the role of frequency hopping in Link 16 security?
• Who should remove a buoy after insertion to declutter displays?
• What is a common limitation of Link 16 regarding bandwidth?
• Can you send a datum through Link 16, and what is required for AMP functionality?
• What does the remote power supply do?
• How does Link 16 provide voice control?
• What type of data do data link messages carry in Link 16?
• Which capability is unique to the MH-60R design?
• What access method does Link 16 use to multiplex communications among many terminals?
• Which statement best describes over-the-horizon targeting with Link 16?
• In Full Link Mode/Suppression Disabled, link transmissions interfering with radar reception may cause what?
• Which statement about Link 16 buoys is NOT a limitation?
• What kind of synchronization does the terminal need to receive messages?
• What kind of unit is the MH-60R in reference to the JTIDS architecture?
• Which of the following best describes common causes of degraded Link 16 performance in the field?
• Which statement about NDL is true?
• Of the total engagements, how many can be delegated and how many can be assigned to the own helicopter?
• What happens if a Link 16 node loses synchronization with the network time?
• What data type are J14.0 messages?
• What do the antennas do?
• In Link 16, what does NM stand for?
• What is the primary function of operator consoles in monitoring Link 16 health?
• Suppression modes are intended to improve interoperability between Link 16 and ESM.
• Link 16 text messages allow for up to how many characters between JTIDS/MIDs units or to the collective address?
• What mode must the MIDS terminal be in to transmit messages on the network?
• How does Link 16 protect data from interception and jamming?
• IPF MED or HIGH settings are intended to preclude limitations in CONUS or OCONUS operations; what must be true about these settings?
• Normal Mode/Suppression Enabled is described as the default mode which allows ESM to activate suppression if sufficient link transmissions are occurring to negatively impact ESM performance.
• What does LRLY do?
• How does a coalition operation utilize Link 16 data sharing?
• Which step is included as part of net participation setup?
• In INCONUS operations, which IPF Override (OVRD) values are appropriate?
• What is the NTR used for?
• Which filter type is used to suppress certain frequencies in the Link 16 sub system's antenna system?
• Which statement about LRLY is true?
• Which statement is a limitation of LPAs?
• What is the primary purpose of the TDMA scheme in Link 16?
• What J-series message is for an air track?
• What information distribution system does Link 16 use?
• How are time slots used in Link 16's TDMA?
• Why is J-Voice not the best option?
• What happens to the track if it turns right after a frame update?
• Which statement best describes the impact of data latency on decision-making in Link 16 missions?
• What does MIDS stand for in Link 16 terminology?
• What is the Joint Network Library?
• What is the purpose of the suppression modes?
• What is the purpose of operator training and drills for Link 16?
• What are the typical steps to power up and configure a MIDS-LVT terminal for net participation?
• Free-draw lines in LPAs are limited to how many segments?
• How often do Link 16 buoys update their position?
• Is FTF access required, and which platform has a limitation regarding generating and delegating assignments?
• Which methods verify the authenticity of received Link 16 messages?
• Why is time synchronization critical in Link 16 operations?
• Which entity provides time synchronization to a unit joining a Link 16 network?
• Which best describes the purpose of an IDL?
• What are the two primary hardware components that constitute a Link 16 network?
• What is the difference between an IDL and an NDL?
• How many surveillance tracks can the MH-60R display?
• What does the Track Sort and Select (TSS) filter do?
• What mitigation is referenced for the J-Voice low volume issue?
• Why are INCONUS limits placed on IPF OVRD?
• Which component provides location to the MIDS to support the PPLI function and also provides timing?
• How do Link 16 networks achieve interoperability with non-NATO partners?
• What capabilities does the MIDS terminal provide?
• What are ROIs for?
• What do the upper/lower antenna band suppression filters (notch filters) do?
• Which statement about Link 16 security and protection is most accurate?
• What is a typical action included in the key management lifecycle when a crypto device is considered compromised?
• What is the difference between data link messages and network management messages in Link 16?
• What is the typical lifecycle for key management in a Link 16 net?
• What does ECCM stand for and why is it important for Link 16?
• What type of data can be shared over Link 16?
• What are NM (network management) messages used for in Link 16?
• What is a common practice for maintaining EMCON readiness while still sharing critical data?
• Which statement best describes the relationship between MIDS-LVT and MIDS-JTRS?
• Link 16 uses what principle to provide multiple and simultaneous nets?
• How are tracks classified on a Link 16 display (for example friend, neutral, hostile)?
• What J-series messages are for PPLI tracks?
• Which type of circle is not allowed in LPAs?
• Can ROMEO receive and transmit J3.7 messages?
• What J-series messages are for system operation?
• What is the primary purpose of Link 16?
• How are net members added or removed during operation?
• What tracks can you fuse on Link 16?
• Which statement about SAR REF points and multiple survivors is true?
• How does Link 16 enforce coalition data sharing restrictions?
• What role does JMPS play in IDL creation?
• What does a Link 16 time slot represent?
• What is the primary purpose of emission control (EMCON) in Link 16?
• What J-series message is for a subsurface track?
• How often are LPAs transmitted?
• When is the limited F2F capability available?
• How is a Network Participation Group different from a net?
• A J3.7 message is prefaced by which brevity term?
• Which approach best supports resilience against link disruption in Link 16 by maintaining alternate routing paths?
• Where is the MIDS main terminal unit located?
• What is OVRD OFF/ON used for?
• What is the role of data validation and error checking in Link 16 transmissions?
• Where is the distribution of Link 16 data to participants executed in the workflow?
• When defining circular LPAs, how is the diameter determined?